Custom inside aluminium panel

Hello once again my friends!

Today’s update is where I create a new custom panel which will cover the rear panel of the chassis, and the floor.. All from one piece of custom cut, brushed, and bent alumunium.

This was a little difficult to make as I do not have access to a metal bender, so I had to bend this panel with the “tools” that I had on hand…
1x table
1x metal shelf
80kg weight (me…)
1x wooden plank

Certainly a challenge, which resulted in a lot of sweating and swearing. 🙂 End result is amazing though 😀

DSC01303

DSC01304

DSC01306

DSC01308

DSC01313

DSC01315

DSC01316

DSC01318

DSC01319

DSC01321

DSC01317

Heaps of work went into getting the notches filed out so that this panel would sit perfectly around any screw holes or pop rivets. I hope to not encounter this again, haha! 😀

Thanks for tuning in!
Justin “MetallicAcid” Ohlsen

Leave a Reply

Your email address will not be published. Required fields are marked *